Our DIY Chicken Coop from Scrap Materials3
Chicken Week ended many days ago. All the same, there’s one mildly important feature in our chicken raising plans that I have yet to share with you: Our chicken coop. Why the delay? Well… in short, the coop wasn’t done when I expected it to be. It was scheduled to be completed at the beginning of Chicken Week… and then at the end of Chicken Week… and then… well, the coop was ready early the following week.
That’s how life goes when you approach projects with a do-it-yourself perspective. Our DIY chicken coop was created by Ryan and Papa over the course of about three weeks. (Ryan spent nearly every free moment he had on putting this puppy together). I owe them a huge thanks! Mostly today’s post is a tour of the coop. If you have technical questions, please leave them in the comments below and I’ll be happy to get back to you with the answer.
The structure of our coop is made entirely of re-used or re-purposed materials. Most of the framing came from a large, old dog house that I mentioned way back in this post. The remainder came from scrap wood that Papa had in his barn (which is where the coop was built). The metal used for the siding and roof were leftovers from when the barn was built. The area under the peak of the roof was put together using wood from our old kitchen cabinets (we remodeled the kitchen this year). Paint for the doors and trim came from a gallon of outdoor paint I purchased last year for the house (it matches our trim and shutters). The only new materials on the coop are the hardware – hinges, clasps and carabiners to keep racoons out. The coop is currently resting on landscape timbers but will eventually sit on cinder blocks.
The coop is 4′ x 6′ in order to provide the recommended 4 square feet of space per bird. Windows on two sides (lined with welded wire secured from the inside) provides for ventilation. Eventually we will also add ventilation at the gable ends. And at some point in the future the windows will receive working shutters to close out drafts on cold nights.
There are doors on three sides of the coop designed to work with the paddock system we have planned. Having a door on all sides of the coop means that no matter which paddock the chickens are using that week, we can leave one door open during daylight hours for easy in-and-out access at the chickens leisure. The fourth “door” is at the back of the coop; the entire bottom half of the back wall opens on hinges. This not only will allow the hens access to the back paddock but will also enable us to more easily clean out the coop when the time comes. Because we’re using the deep liter method for the bedding, clean outs should be infrequent (somewhere between every 2-6 months). It cost about $11 to (deeply) fill the coop and nesting boxes with pine shavings from Tractor Supply Company.
Speaking of deep liter, the floor of the coop is lined with vinyl flooring to make clean up easier. It’s high quality vinyl too – a remnant from my in-law’s kitchen flooring! (Thanks again!!!)
On the east side of the coop there are two nesting boxes. (You should have one nesting box for every four laying hens; two boxes will be just right for our six girls.) The roof of each box lifts up on hinges for easy access to eggs without having to crawl into the coop. These also close with a latch and carabiner to keep pesky but nimble racoons out. Nesting boxes are topped with the same metal used for the roof. A metal roof allows us to collect rain water from the coop without worrying about dangerous chemicals from commercial shingles leaching into the water. Our intent is to use the water for the chickens but more design thought and work is needed to make a healthy, sustainable system.
Inside the coop hens are able to roost on the trusses of the roof structure. There are a few areas that need weatherproofing with a wee bit of caulk. But even with that in mind, it is a very comfortable structure for our hens to call home.
What do you think? Any thoughts on how we could make the coop even better? Any innovations you’ve used for your chickens that you think we should consider? As always, I’m 100% open to any ideas you’d like to send our way!